- 17 - Hardware Installation Process
English
IDE1
IDE2
1
6) IDE1/ IDE2 (IDE1/IDE2 Connector)
Important Notice:
Please connect first harddisk to IDE1
and connect CDROM to IDE2.
5) FDD (Floppy Connector)
1
7) PWR_LED
MPD+
MPD-
MPD-
1
PWR_LED is connect with the system power
indicator to indicate whether the system is
on/off. It will blink when the system enters
suspend mode.
If you use dual color LED, power LED will turn
to another color.
Please connect the floppy drive ribbon cables
to FDD. It supports 360K,1.2M,1.44M and
2.88Mbytes floppy disk types.
The red stripe of the ribbon cable must be the
same side with the Pin1.
8)DIMM_LED
Do not remove memory modules while
DIMM LED is on. It might cause short or
other unexpected damages due to the
2.5V stand by voltage. Remove memory
modules only when AC Power cord is
disconnected.
+
-
To Next Page
Loading...
