Hardware Installation- 27 -
English
19) BATTERY
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's
instructions.
If you want to erase CMOS...
1. Turn OFF the computer and unplug the power cord.
2. Take out the battery gently and put it aside for about 10 minutes
(Or you can use a metal object to connect the positive and
negative pins in the battery holder to make them short for one
minute).
3. Re-install the battery.
4. Plug the power cord and turn ON the computer.
To Next Page
Loading...
