EasyManuals Logo

Gigabyte GA-945P-DS3 User Manual

Gigabyte GA-945P-DS3
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
GA-945P-DS3/S3 Motherboard - 16 -
English
1-5 Installation of Expansion Cards
You can install your expansion card by following the steps outlined below:
1. Read the related expansion card's instruction document before install the expansion card into the
computer.
2. Remove your computer's chassis cover, screws and slot bracket from the computer.
3. Press the expansion card firmly into expansion slot in motherboard.
4. Be sure the metal contacts on the card are indeed seated in the slot.
5. Replace the screw to secure the slot bracket of the expansion card.
6. Replace your computer's chassis cover.
7. Power on the computer, if necessary, setup BIOS utility of expansion card from BIOS.
8. Install related driver from the operating system.
Installing a PCI Express x16 expansion card:
Please align the VGA card to the onboard
PCI Express x16 slot and press firmly
down on the slot. Make sure your VGA
card is locked by the latch at the end of
the PCI Express x16 slot. When you try
uninstall the VGA card, please gently
press the latch as the picture to the left
shows to release the card.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gigabyte GA-945P-DS3 and is the answer not in the manual?

Gigabyte GA-945P-DS3 Specifications

General IconGeneral
SocketLGA 775
Form FactorATX
Memory Slots4
Maximum Memory4 GB
USB Ports8 x USB 2.0
Front Side Bus1066/800/533 MHz
Expansion Slots1 x PCI-E x16, 3 x PCI-E x1, 3 x PCI
Storage Interface4 x SATA 3Gb/s, 1 x PATA
AudioRealtek ALC883
LANGigabit Ethernet
Supported CPUIntel Core 2 Duo, Pentium D, Pentium 4
Memory TypeDDR2
ChipsetIntel 945P

Related product manuals