GA-965P-DQ6 Motherboard - 78 -
English
Step 3:
Use the ARROW keys on your keyboard to select Intel(R) ICH8R/DO/DH SATA RAID Controller
(Desktop ICH8R)* (Figure 16) and press ENTER. Then the system will load the SATA driver from the
floppy disk.
Figure 16
Figure 17
If a message appears saying one or some file(s) cannot be found, please check the floppy
disk or copy the correct SATA driver again from the motherboard driver CD.
Step 4:
When the screen as shown below appears, press ENTER to continue the SATA driver installation from
the floppy disk. The driver installation will be finished in about one minute.
"*" If you set the SATA RAID/AHCI Mode item in BIOS Setup to AHCI mode, please select
Intel(R) ICH8R/DO/DH SATA AHCI Controller (Desktop ICH8R).
Windows Setup
ENTER=Select F3=Exit
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
Intel(R) ICH8R/DO/DH SATA RAID Controller (Desktop ICH8R)
Intel(R) ICH8R/DO/DH SATA AHCI Controller (Desktop ICH8R)
Intel(R) 631xESB/632xESB SATA RAID Controller (Server/Workstation ESB2)
Intel(R) 631xESB/632xESB SATA AHCI Controller (Server/Workstation ESB2)
Windows Setup
S=Specify Additional Device ENTER=Continue F3=Exit
Setup will load support for the following mass storage device(s):
Intel(R) ICH8R/DO/DH SATA RAID Controller (Desktop ICH8R)
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
To Next Page
Loading...
Need help?
General
