Appendix- 97 -
English
1. : This button provides you more controls over "dts NEO:PC".
Music Mode ; Cinema Mode
2. "dts NEO : PC" :
Press this button to enable or disable the dts NEO : PC function.
Enabling dts NEO : PC allows the system to transform ordinary 2-channel stereo content into
4-, 6-, or 8- channel surround sound, depending on your speaker configurations.
3. "dts INTERACTIVE" :
If your surround sound system is connected via an external decoder, click the Audio I/O tab in the
Audio Control Panel. Either click DTS Interactive in the upper left list or click the dts INTERACTIVE
button at the center bottom of the Audio Control
Panel. And click the dts NEO : PC button.
The system will then simulate 5.1 channel
surround sound playback from two-channel
content.
Enabling the DTS (Digital Theater Systems) function
Before DTS is enabled, you would get only 2-channel output signals (from the
front speakers) when playing 2-channel music. You must play 4-, 6-, or 8-
channel music sources to produce 4-, 6-, or 8- channel audio effects.
DTS control button
With DTS enabled, the system will transform two-channel stereo source material into multi-channel
audio output, creating a virtual surround sound environment.
After installing the audio driver, at the center bottom of the Audio Control
Panel, you should find the DTS control button as shown below:
To Next Page
Loading...
Need help?
General
