Gigabyte GA-AM1M-S2P - SATA 6 Gb;S Connectors; Front Panel Header

- 13 -
5) SATA3 0/1 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device.
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
7
0 1
SATA3
1
1
7
6) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status indicator
on the chassis to this header according to the pin assignments below. Note the positive and negative pins
before connecting the cables.
Power LED
1
2
19
20
CI-
CI+
PW- SPEAK+ SPEAK-
PW+
HD-
RES+
HD+
RES-
Hard Drive
Activity LED
Reset
Switch
Chassis Intrusion
Header
Power Switch
Speaker
F_USB30
F_U
B_ 
F_  F_  
 
_
B
BS_ 
B
SB_ 
B
_S

S_
_
B
_ U
_ 
B
 

 
S  
 
123
 
123
 
123
 
123
1
1
1
1
BSS
S
_S  
SSU 
 
1 2 3  
 S3
BSSS 
• PW (Power Switch):
Connects to the power switch on the chassis front panel.
You may congure the way to turn off your system using
the power switch (refer to Chapter 2, "BIOS Setup," "Power
Management," for more information).
• PLED/PWR_LED Power LED:
Connects to the power status
indicator on the chassis front
panel. The LED is on when the
system is operating. The LED is
off when the system is in S3/S4
sleep state or powered off (S5).
System Status LED
S0 On
S3/S4/S5 Off
• SPEAK (Speaker):
Connects to the speaker on the chassis front panel. The system reports system startup status by issuing a
beep code. One single short beep will be heard if no problem is detected at system startup.
• HD (Hard Drive Activity LED):
Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is
reading or writing data.
• RES (Reset Switch):
Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the
computer freezes and fails to perform a normal restart.
• CI (Chassis Intrusion Header):
Connects to the chassis intrusion switch/sensor on the chassis that can detect if the chassis cover has been
removed. This function requires a chassis with a chassis intrusion switch/sensor.
The front panel design may differ by chassis. A front panel module mainly consists of power switch,
reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis
front panel module to this header, make sure the wire assignments and the pin assignments are
matched correctly.
PLED-
PLED+
Power LED
PWR_LED-
PWR_LED+