Gigabyte GA-B85M-D3H-A - 2-5 Peripherals

& Ipv4 PXE Support
 EnablesordisablesIPv4PXESupport.ThisitemiscongurableonlywhenNetwork stack is enabled.
& Ipv6 PXE Support
 EnablesordisablesIPv6PXESupport.ThisitemiscongurableonlywhenNetwork stack is enabled.
& Administrator Password
 Allowsyoutocongureanadministratorpassword.Press<Enter>onthisitem,typethepassword,andthen
press<Enter>.Youwillberequestedtoconrmthepassword.Typethepasswordagainandpress<Enter>.You
must enter the administrator password (or user password) at system startup and when entering BIOS Setup.
Differing from the user password, the administrator password allows you to make changes to all BIOS settings.
& User Password
 Allowsyoutocongureauserpassword.Press<Enter>onthisitem,typethepassword,andthenpress<Enter>.
Youwillberequestedtoconrmthepassword.Typethepasswordagainandpress<Enter>.Youmustenter
the administrator password (or user password) at system startup and when entering BIOS Setup. However, the
user password only allows you to make changes to certain BIOS settings but not all.
To cancel the password, press <Enter> on the password item and when requested for the password, enter the
correctonerst.Whenpromptedforanewpassword,press<Enter>withoutenteringanypassword.Press
<Enter>againwhenpromptedtoconrm.
 NOTE:BeforesettingtheUserPassword,besuretosettheAdministratorPasswordrst.
2-5 Peripherals
& InitialDisplayOutput
 SpeciestherstinitiationofthemonitordisplayfromtheinstalledPCI,PCIExpressgraphicscardorthe
onboard graphics.
IGFX   Setstheonboardgraphicsastherstdisplay.
PCIe1Slot SetsthegraphicscardonthePCIEX16slotastherstdisplay.(Default)
PCIe2Slot SetsthegraphicscardonthePCIEX4slotastherstdisplay.
PCI   SetsthegraphicscardonthePCIslotastherstdisplay.
- 28 -