Gigabyte GA-B85M-DASH - 2-2 M.I.T.

- 23 -
&
Memory Initial Parameter Set
(Note)

Auto Lets BIOS automatically congure this setting. (Default)

Normal Speed Loads the timing prol for normal frequency memory.

High Speed Loads the timing prol for high frequency overclocking memory.
&
Memory Enhancement Settings
Provides three different memory performance enhancement settings: Normal (basic performance), En-
hanced Stability, and Enhanced Performance. (Default: Normal)
&
Memory Timing Mode
Manual and Advanced Manual allows the Channel Interleaving, Rank Interleaving, and memory tim-
ing settings below to be congurable. Options are: Auto (default), Manual, Advanced Manual.
&
ProleDDRVoltage
When using a non-XMP memory module or ExtremeMemoryProle(X.M.P.) is set to Disabled, this
item will display as 1.50V. When ExtremeMemoryProle(X.M.P.) is set to Prole1 or Prole2, this
item will display the value based on the SPD data on the XMP memory.
&
Channel Interleaving
Enables or disables memory channel interleaving. Enabled allows the system to simultaneously access
different channels of the memory to increase memory performance and stability. Auto lets the BIOS au-
tomatically congure this setting. (Default: Auto)
&
Rank Interleaving
Enables or disables memory rank interleaving. Enabled allows the system to simultaneously access dif-
ferent ranks of the memory to increase memory performance and stability. Auto lets the BIOS automati-
cally congure this setting. (Default: Auto)
(Note) This item is present only when you install a CPU and a memory module that support this feature.
`
Channel A/B Timing Settings
This sub-menu provides memory timing settings for each channel of memory. This sub-menu provides
memory timing settings for each channel of memory. The respective timing setting screens are congurable
only when Memory Timing Mode is set to Manual or Advanced Manual. Note: Your system may become
unstable or fail to boot after you make changes on the memory timings. If this occurs, please reset the board
to default values by loading optimized defaults or clearing the CMOS values.
`
Advanced Voltage Settings
This section provides CPU voltage control options.
`
PC Health Status
&
Reset Case Open Status

Disabled Keeps or clears the record of previous chassis intrusion status. (Default)

Enabled Clears the record of previous chassis intrusion status and the Case Open eld
will show "No" at next boot.
&
Case Open
Displays the detection status of the chassis intrusion detection device attached to the motherboard CI
header. If the system chassis cover is removed, this eld will show "Yes", otherwise it will show "No". To
clear the chassis intrusion status record, set Reset Case Open Status to Enabled, save the settings to
the CMOS, and then restart your system.