Gigabyte GA-D425TUD - Product Specifications

Hardware Installation
- 10 -
1-2 ProductSpecications
j
Only for GA-D525TUD.
k
Only for GA-D425TUD.
CPU  Built in with an Intel
®
Dual-core Atom
™
D525j/ Intel
®
Single-core Atom
™
D425k
processor (1.8 GHz)
* Do not disassemble the onboard CPU/chipset and the heatsinks/fan by yourself to
avoid damage to these components.
 1M L2 cachej/512K L2 cachek
Chipset  Intel
®
NM10
Memory  2 x 1.5V DDR3 DIMM sockets supporting up to 4 GB of system memory
* Due to a Windows 32-bit operating system limitation, when more than 4 GB of physical
memory is installed, the actual memory size displayed will be less than the size of
the physical memory installed.
 Support for DDR3 800 MHz memory modules
(GotoGIGABYTE'swebsiteforthelatestsupportedmemoryspeedsandmemory
modules.)
Audio  Realtek ALC887 codec
 HighDenitionAudio
 2/4/5.1/7.1-channel
* To enable 7.1-channel audio, you have to use an HD front panel audio module and
enable the multi-channel audio feature through the audio driver.
LAN  Realtek GbE LAN Chip (10/100/1000 Mbit)
Expansion Slots  1 x PCI slot
Storage Interface  Chipset:
- 2 x SATA 3Gb/s connectors (SATA2_0, SATA2_1) supporting up to 2 SATA
3Gb/s devices
 GIGABYTESATA2/JMicronJMB363chip:
- 1 x IDE connector supporting ATA-133/100/66/33 and up to 2 IDE devices
- 2 x SATA 3Gb/s connectors (GSATA2_0, GSATA2_1) supporting up to 2
SATA 3Gb/s devices
  * WheninstallingWindowsXPontotheharddriveconnectedtotheJMicronJMB363
controller, be sure to connect the optical drive to a SATA port controlled by the Intel
chipset.
- SupportforSATARAID0,RAID1,andJBOD
USB  Chipset:
- Up to 8 USB 2.0/1.1 ports (4 on the back panel, 4 via the USB brackets
connected to the internal USB headers)
Internal
Connectors
 1 x 20-pin ATX main power connector
 1 x 4-pin ATX 12V power connector
 1 x IDE connector
 4 x SATA 3Gb/s connectors
 1 x CPU fan header
 1 x system fan header
 1 x front panel header
 1 x front panel audio header