Gigabyte GA-D425TUD - Page 18

Hardware Installation
- 18 -
6) SATA2_0/1 (SATA 3Gb/s Connectors, Controlled by NM10 Chipset)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device.
PinNo. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
SATA2_0
SATA2_1
1
DEBUG
PORT
G.QBOFM
7
DEBUG
PORT
G.QBOFM
7) GSATA2_0/1 (SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2/JMicron
JMB363)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
EachSATA connectorsupportsa singleSATA device.The GIGABYTESATA2/JMicron JMB363con-
trollersupportsRAID0,RAID1,andJBOD.RefertoChapter5,"ConguringSATAHardDrive(s),"for
instructionsonconguringaRAIDarray.
PinNo. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
ARAID0orRAID1congurationrequiresatleasttwoharddrives.
GSATA2_1
GSATA2_0
1
DEBUG
PORT
G.QBOFM
7
DEBUG
PORT
G.QBOFM