Gigabyte GA-E2500N

To Next Page

To Previous Page

- 18 -

` Advanced Voltage Settings

This sub-menu allows you to set CPU, chipset and memory voltages.

` PC Health Status

& ResetCaseOpenStatus

Disabled Keeps or clears the record of previous chassis intrusion status. (Default)

Enabled Clears the record of previous chassis intrusion status and the CaseOpeneldwill

show "No" at next boot.

& CaseOpen

Displays the detection status of the chassis intrusion detection device attached to the motherboard CI

header.Ifthesystemchassiscoverisremoved,thiseldwillshow"Yes",otherwiseitwillshow"No".To

clear the chassis intrusion status record, set ResetCaseOpenStatus to Enabled, save the settings to

the CMOS, and then restart your system.

& CPU Vcore/DRAM Voltage/+3.3V/+5V/+12V

Displays the current system voltages.

& CPU/System Temperature

Displays current CPU/system temperature.

& CPU/SystemFanSpeed

Displays current CPU/system fan speeds.

& CPUFanSpeedControl

Allows you to determine whether to enable the fan speed control function and adjust the fan speed.

Normal Allows the fan to run at different speeds according to the temperature. You can adjust

the fan speed with EasyTune based on your system requirements. (Default)

Silent Allows the fan to run at slow speeds.

Manual Allows you to control the fan speed under the FanSpeedPercentage item.

Full Speed Allows the fan to run at full speeds.

& FanSpeedPercentage

 Allowsyoutocontrolthefanspeed.ThisitemiscongurableonlywhenCPUFanSpeedControl is set

to Manual. Options are: 0.75 PWM value /

C ~ 2.50 PWM value /

& SystemFanSpeedControl