Gigabyte GA-EG45M-DS2H - Page 50

GA-EG45M-DS2H Motherboard - 50 -
First/Second/Third Boot Device
Specifies the boot order from the available devices. Use the up or down arrow key to select a
device and press <Enter> to accept. Options are: Floppy, LS120, Hard Disk, CDROM, ZIP,
USB-FDD, USB-ZIP, USB-CDROM, USB-HDD, Legacy LAN, Disabled.
Password Check
Specifies whether a password is required every time the system boots, or only when you enter
BIOS Setup. After configuring this item, set the password(s) under the Set Supervisor/User
Password item in the BIOS Main Menu.
Setup A password is only required for entering the BIOS Setup program. (Default)
System A password is required for booting the system and for entering the BIOS Setup
program.
HDD S.M.A.R.T. Capability
Enables or disables the S.M.A.R.T. (Self Monitoring and Reporting Technology) capability of your
hard drive. This feature allows your system to report read/write errors of the hard drive and to
issue warnings when a third party hardware monitor utility is installed. (Default: Disabled)
CPU Multi-Threading
(Note)
Allows you to determine whether to enable all CPU cores and multi-threading function when using
an Intel
®
CPU that supports multi-core technology. This feature only works for operating systems
that support multi-processor mode.
Enabled Enables all CPU cores and multi-threading capability. (Default)
Disabled Enables only one CPU core.
Limit CPUID Max. to 3
(Note)
Allows you to determine whether to limit CPUID maximum value. Set this item to Disabled for
Windows XP operating system; set this item to Enabled for legacy operating system such as
Windows NT4.0. (Default: Disabled)
No-Execute Memory Protect
(Note)
Enables or disables Intel
®
Execute Disable Bit function. This function may enhance protection for
the computer, reducing exposure to viruses and malicious buffer overflow attacks when working
with its supporting software and system. (Default: Enabled)
CPU Enhanced Halt (C1E)
(Note)
Enables or disables Intel
®
CPU Enhanced Halt (C1E) function, a CPU power-saving function in
system halt state. When enabled, the CPU core frequency and voltage will be reduced during
system halt state to decrease power consumption. (Default: Enabled)
C2/C2E State Support
(Note)
Allows you to determine whether to let the CPU enter C2/C2E mode in system halt state. When
enabled, the CPU core frequency and voltage will be reduced during system halt state to descrease
power consumption. (Default: Disabled)
C4/C4E State Support
(Note)
Allows you to determine whether to let the CPU enter C4/C4E mode in system halt state. When
enabled, the CPU core frequency and voltage will be reduced during system halt state to descrease
power consumption. C4/C4E state is a more enhanced power-saving state than C2/C2E. This
item is configurable only if the C2/C2E State Support option is enabled. (Default: Disabled)