Gigabyte GA-EP41-UD3L - Page 37

- 37 - BIOS Setup
(G)MCH Frequency Latch
Allows you to x the chipset frequency at system bootup. Options for adjusting memory multiplier below
may differ according to the xed frequency. Options are: Auto (default), 200MHz, 266MHz, 333MHz.
System Memory Multiplier (SPD)
Allows you to set the system memory multiplier. Options are dependent on CPU FSB and the (G)MCH
Frequency Latch settings. Auto sets memory multiplier according to memory SPD data. (Default: Auto)
Memory Frequency (Mhz)
The rst memory frequency value is the normal operating frequency of the memory being used; the
second is the memory frequency that is automatically adjusted according to the CPU Host Frequency
(Mhz) and System Memory Multiplier settings.
DRAM Timing Selectable (SPD)
Manual allows all DRAM timing control items below to be congurable. Options are: Auto (default),
Manual.
>>>>> Standard Timing Control
CAS Latency Time
Options are: Auto (default), 3~7.
tRCD
Options are: Auto (default), 1~15.
tRP
Options are: Auto (default), 1~15.
tRAS
Options are: Auto (default), 1~63.
>>>>> Advanced Timing Control
Advanced Timing Control
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Advanced Timing Control
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

x tRRD 3 Auto
x tWTR 3 Auto
x tWR 5 Auto
x tRFC 44 Auto
x tRTP 3 Auto
x Command Rate (CMD) 0 Auto
>>>>> Channel A

Channel A Timing Settings [Press Enter]

Channel A Driving Settings [Press Enter]
>>>>> Channel B

Channel B Timing Settings [Press Enter]

Channel B Driving Settings [Press Enter]