Gigabyte GA-EP41-UD3L - Integrated Peripherals

BIOS Setup - 46 -
2-6 Integrated Peripherals
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Integrated Peripherals
On-Chip Primary PCI IDE [Enabled]
On-Chip SATA Mode [Auto]
x PATA IDE Set to Ch.0 Master/Slave
SATA Port 0/2 Set to Ch.2 Master/Slave
SATA Port 1/3 Set to Ch.3 Master/Slave
Azalia Codec [Auto]
Onboard H/W LAN [Enabled]
Green LAN [Disabled]

SMART LAN [Press Enter]
Onboard LAN Boot ROM [Disabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
USB 1.0 Controller [Enabled]
USB 2.0 Controller [Enabled]
USB Keyboard Function [Disabled]
USB Mouse Function [Disabled]
USB Storage Function [Enabled]
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

On-Chip Primary PCI IDE
Enables or disables the rst integrated IDE controller. (Default: Enabled)
On-Chip SATA Mode
Congures the integrated SATA controller.
Disabled Disables the integrated SATA controller.
Auto Lets the BIOS set SATA devices to Combined or Enhanced mode.
If your onboard SATA controller is automatically congured to Combined mode,
you can manually re-congure it to Enhanced mode as needed. (Default)
Combined Sets all SATA devices to operate in PATA mode. Combined allows a maximum
of 4 ATA devices to be used simultaneously: two PATA devices plus two SATA
devices.
Enhanced Sets all SATA devices to operate in SATA mode.
Non-Combined Sets all SATA devices to operate in PATA mode and disables the integrated IDE
controller.
PATA IDE Set to
This item is congurable only if the On-Chip SATA Mode is set to Combined.
Ch.0 Master/Slave Sets the IDE channels to Ch. 0 Master/Slave. (Default)
Ch.1 Master/Slave Sets the IDE channels to Ch. 1 Master/Slave.
Disabled Disables the integrated IDE controller when Non-Combined is selected.
SATA Port 0/2 Set to
This value is dependent on the On-Chip SATA Mode and PATA IDE Set to settings.
When PATA IDE Set to is congured to Ch. 1 Master/Slave, this option will be automatically set to Ch. 0
Master/Slave.