Gigabyte GA-EP43C-DS3 - Page 49

- 49 - BIOS Setup
Delay For HDD (Secs)
Allows you to set a delay time for the BIOS to initialize the hard drive as the system boots up.
The adjustable range is from 0 to 15 seconds. (Default: 0)
Full Screen LOGO Show
Allows you to determine whether to display the GIGABYTE Logo at system startup. Disabled
displays normal POST message. (Default: Enabled)
Init Display First
Specifies the first initiation of the monitor display from the installed PCI graphics card or
PCI Express graphics card.
PCI Sets the PCI graphics card as the first display. (Default)
PEG Sets PCI Express graphics card on the PCI Express x16 slot as the first
display.