- 11 -
DVI-D Port
Connect a monitor that supports DVI-D connection to this port. Please note that the actual resolutions
supported are dependent on the monitor being used and support for 2560x1600 resolution requires both
a monitor and cable that support Dual Link DVI.
USB 3.0/2.0 Port
HDMI Port
The HDMI port is HDCP compliant and supports Dolby True HD and DTS HD
output. You can use this port to connect your HDMI-supported monitor. The maximum supported resolution
is 4096x2160
, but the actual resolutions supported are dependent on the monitor being used.
After installing the HDMI device, make sure to set the default sound playback device to HDMI.
•
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to prevent
an electrical short inside the cable connector.
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following
describes the states of the LAN port LEDs.
In order to get better playback quality, when playing the Blu-ray™ discs, refer to the recommended system
• AMD A series processors
•
•
•
is enabled. Whether Hardware Acceleration can be enabled for 3D Blu-ray discs is dependent on the
•
The line in jack. Use this audio jack for line in devices such as an optical drive, walkman, etc.
The line out jack. Use this audio jack for a headphone or 2-channel speaker. This jack can be used to
supported is 1920x1200 when using an FM2 APU.
Activity LED
Connection/
Speed LED
LAN Port
Activity LED:Connection/Speed LED:
State Description
Orange 1 Gbps data rate
Green 100 Mbps data rate
Off 10 Mbps data rate
State Description
Blinking Data transmission or receiving is occurring
Off No data transmission or receiving is occurring
To Next Page
Loading...
