- 31 -
Before you begin
•
•
• Motherboard driver disk.
•
•
•
A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available SATA
port on the motherboard. Then connect the power connector from your power supply to the hard drive.
For the BIOS Setup menus,
refer to Chapter 2, "BIOS Setup," "Integrated Peripherals."
Steps:
1.
Ensure is enabled under Peripherals. Set to RAID.
2. -
tings and exit BIOS Setup. Refer to "C-2" for more information.
Chapter 3 Appendix
The BIOS Setup menus described in this section may differ from the exact settings for your mother-
board. The actual BIOS Setup menu options you will see shall depend on the motherboard you have
and the BIOS version.
This mode supports Windows 8 64-bit installation only.
\BootDrv\UEFI RAID Utility folder in your motherboard driver
Step:
In BIOS Setup, go to and set to Windows 8 and CSM Support to Never. Save the
changes and exit BIOS Setup.
Running the UEFI RAID Utility
-
screen. To run the UEFI RAID utility, enter the following commands.
You can enter the commands at Shell or x
Checking Disk Information
To see the hard drive information, enter the following commands and press <Enter>. You will see CONTROLLER
LIST and DISK LIST displayed on the screen
rcadm -M -qa
Creating a RAID Array
To create a RAID array, refer to the following examples to enter the commands and press <Enter>. When suc-
ceeded, the message which says "created sucessfully" will appear.
To Next Page
Loading...
