Hardware Installation- 21 -
English
7) IDE1 / IDE2 (IDE Connector)
An IDE device connects to the computer via an IDE connector. One IDE connector can connect to one
IDE cable, and the single IDE cable can then connect to two IDE devices (hard drive or optical drive). If
you wish to connect two IDE devices, please set the jumper on one IDE device as Master and the other
as Slave (for information on settings, please refer to the instructions located on the IDE device).
2
40
1
39
IDE2 IDE1
8) S_ATA0/1/2/3_SB (SATA 3Gb/s Connectors, Controlled by nForce4 Ultra/SLI*)
SATA 3Gb/s can provide up to 300MB/s transfer rate while SATA provides up to 150MB/s
transfer rate. Please refer to the BIOS setting for the SATA controller(s)and install the proper
driver in order to work properly.
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5RXN
6 RXP
7 GND
7
1
"*" Only for GA-K8NF9 Ultra(2.0).
To Next Page
Loading...