Gigabyte GA-M750SLI-DS4 - Dram Configuration; Memory Clock

GA-M750SLI-D4 Motherboard - 40 -
Memory Controller Freq.
(Note)
Allows you to alter the memory controller frequency for the installed CPU. The adjustable range is
dependent on the CPU being used. (Default: Auto)
DRAM Configuration
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
DRAM Configuration
SLI-Ready Memory [Disabled] Not Detected
Set Memory Clock [Auto]
x Memory Clock x4.00 800Mhz
DCTs Mode
(Note)
[Unganged]
DDRII Timing Items [Auto] SPD Auto
x CAS# latency Auto 6T 6T
x RAS to CAS R/W Delay Auto 6T 6T
x Row Precharge Time Auto 6T 6T
x Minimum RAS Active Time Auto 18T 18T
x 1T/2T Command Timing Auto - - - -
x TwTr Command Delay Auto 3T 3T
x Trfc0 for DIMM1 Auto 105ns 105ns
x Trfc2 for DIMM2 Auto - - - -
x Trfc1 for DIMM3 Auto - - - -
x Trfc3 for DIMM4 Auto - - - -
x Write Recovery Time Auto 6T 6T
x Precharge Time Auto 4T 4T
x Row Cycle Time Auto 25T 25T
x RAS to RAS Delay Auto 3T 3T
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level``
SLI-Ready Memory
Allows you to enable or disable the SLI-Ready (EPP) memory function. (Default: Disabled)
Set Memory Clock
Determines whether to manually set the memory clock. Auto lets BIOS automatically set the
memory clock as required. Manual allows the memory clock control item below to be configurable.
(Default: Auto)
Memory Clock
This option is configurable only when Set Memory Clock is set to Manual.
When you use an AM2 CPU:
DDR 400 Sets Memory Clock to DDR 400.
DDR 533 Sets Memory Clock to DDR 533.
DDR 667 Sets Memory Clock to DDR 667.
DDR 800 Sets Memory Clock to DDR 800.
When you use an AM2+ CPU:
x2.00 Sets Memory Clock to x2.00.
x2.66 Sets Memory Clock to x2.66.
x3.33 Sets Memory Clock to x3.33.
x4.00 Sets Memory Clock to x4.00.
x5.33 Sets Memory Clock to x5.33.
(Note) This item appears only if you install a CPU that supports this feature.