Gigabyte GA-M750SLI-DS4 - Page 78

GA-M750SLI-DS4 Motherboard - 78 -
Step 6:
After assigning the RAID drives, press <F7>. A message which says "All data on new(or added) disks
may be overwritten. Continue?" appears (Figure 5). To overwrite the data in the selected hard drives,
press <Y> to confirm or press <N> to cancel. (If the hard drives contain a previously created RAID
array, you need to press <Y> to clear the data in the hard drives.) If you confirm Yes to the prompt
above, the "Clear MBR?" prompt appears. Press <Y> to clear or <N> to abort. (We recommend that you
clear the MBR to reduce drive errors.)
Figure 5
Figure 4
Step 5:
Next, select the hard drives which you wish to be included in the disk array. The Free Disks block
displays the information about the SATA hard drives that are available for use as RAID array drives.
Press <Tab> to move to the Free Disks block. Select the target hard drives using the up or down arrow
key and use the right arrow key to add the hard drives to the Array Disks block (Figure 4).
MediaShield BIOS Feb 13 2008
- Define a New Array -
RAID Mode: Striped Stripe Block: Optimal
[
JJ
JJ
J] Add
[
II
II
I] Del
[ESC] Quit [F6] Back [F7] Finish [TAB] Navigate [
KLKL
KLKL
KL] Select [ENTER] Popup
0.0 ST3120026AS 111.79GB
0.2 ST3120026AS 111.79GB
Free Disks
Port Disk Model Capacity
Array Disks
Port Disk Model Capacity
Clear disk data ?
[Y] YES [N] NO
RAID Mode: Striped Stripe Block: Optimal
[
JJ
JJ
J] Add
[
II
II
I] Del
[ESC] Quit [F6] Back [F7] Finish [TAB] Navigate [
KLKL
KLKL
KL] Select [ENTER] Popup
1.0.M ST3120026AS 111.79GB
1.1.M ST3120026AS 111.79GB
MediaShield BIOS Feb 13 2008
- Define a New Array -
Array Disks
Port Disk Model Capacity
Free Disks
Port Disk Model Capacity
All data on new(or added) disks may be overwritten. Contiune?
[Y] YES [N] NO