- 45 - BIOS Setup
Onboard LAN Function
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item
to Disabled.
Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
OnBoard PCIE Device
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
OnBoard PCIE Device
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level`
Onboard LAN Function [Enabled]
Onboard LAN Boot ROM [Disabled]
` SMART LAN [Press Enter]
Onboard ESATA-II Ctrl [Enabled]
Onboard ESATA-II Ctrl Mode [IDE]
Onboard GSATA-II Ctrl [Enabled]
Onboard GSATA-II Ctrl Mode [IDE]
OnChip SATA Controller (AMD SB600 chip)
Enables or disables the integrated SATA controller. (Default: Enabled)
OnChip SATA Type (AMD SB600 chip)
Configures the operating mode of the integrated SATA controller.
Native IDE Allows the SATA controller to operate in Native IDE mode. (Default)
Enable Native IDE mode if you wish to install operating systems that support
Native mode, e.g. Windows XP/2000.
RAID Enables RAID for the SATA controller.
Legacy IDE Allows the SATA controller to operate in Legacy IDE mode. In Legacy mode the
SATA controller uses dedicated IRQs that cannot be shared with other device.
Set this option to Legacy IDE if you wish to install operating systems that do not
support Native mode, e.g. Windows 9X/ME
SATA ->AHCI Configures the SATA controller to AHCI mode. Advanced Host Controller
Interface (AHCI) is an interface specification that allows the storage driver to
enable advanced Serial ATA features such as Native Command Queuing and
hot plug. For more information about AHCI, please visit Intel's website.
To Next Page
Loading...
