Gigabyte GA-MA790FX-DS5 - Page 84

GA-MA790FX-DS5 Motherboard - 84 -
The BIOS Setup menus described in this section may differ from the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
Step 2:
Save changes and exit BIOS Setup.
For example, if you wish to create RAID with hard drives on the GSATAII_1 and GSATAII_2 connectors,
ensure that Onboard GSATA-II Ctrl is enabled. Set Onboard GSATA-II Ctrl Mode to RAID (Figure
2). If you do not want to create RAID, set this item to IDE or AHCI, depending on your need.
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
OnBoard PCIE Device
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level`
Onboard LAN Function [Enabled]
Onboard LAN Boot ROM [Disabled]
` SMART LAN [Press Enter]
Onboard ESATA-II Ctrl [Enabled]
Onboard ESATA-II Ctrl Mode [IDE]
Onboard GSATA-II Ctrl [Enabled]
Onboard GSATA-II Ctrl Mode [RAID]
Figure 2
For example, if you wish to create RAID with hard drives on the eSATA 3Gb/s ports, ensure that
Onboard ESATA-II Ctrl is enabled. Set Onboard ESATA-II Ctrl Mode to RAID (Figure 2). If you do
not want to create RAID, set this item to IDE or AHCI, depending on your need.
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
OnBoard PCIE Device
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level`
Onboard LAN Function [Enabled]
Onboard LAN Boot ROM [Disabled]
` SMART LAN [Press Enter]
Onboard ESATA-II Ctrl [Enabled]
Onboard ESATA-II Ctrl Mode [RAID]
Onboard GSATA-II Ctrl [Enabled]
Onboard GSATA-II Ctrl Mode [IDE]
Figure 2