- 51 - BIOS Setup
2-9 MB Intelligent Tweaker(M.I.T.)
HT Link Frequency
Allows you to manually set the frequency for the HT Link between the CPU and chipset.
Auto lets BIOS automatically set the HT Link frequency as required. Options are: Auto (default),
200 MHz, 400 MHz, 600 MHz, 800 MHz, 1 GHz.
PCIE Clock (MHz)
Allows you to manually set the PCIe clock frequency. The adjustable range is from 100 MHz to
200 MHz. Auto sets the PCIe clock frequency to standard 100 MHz. (Default: Auto)
Set Memory Clock
Determines whether to manually set the memory clock. Auto lets BIOS automatically set the
memory clock as required. Manual allows the memory clock control item below to be configurable.
(Default: Auto)
Memory Clock
This option is configurable only when Set Memory Clock is set to Manual. Options are: DDR 400,
DDR 533, DDR 667, DDR 800.
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
MB Intelligent Tweaker(M.I.T.)
HT Link Frequency [Auto]
PCIE Clock (MHz) [Auto]
Set Memory Clock [Auto]
x Memory Clock DDR 533
` DRAM Configuration [Press Enter]
CPU Clock Ratio [Auto]
CPU Host Clock Control [Auto]
x CPU Frequency (MHz) 200
********
System Voltage Optimized
********
System Voltage Control [Auto]
x CPU Voltage Control Normal
Normal CPU Vcore 1.3500V
x DDR2 Voltage Control Normal
x NorthBridge Volt Control Normal
x SouthBridge Volt Control Normal
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level`
• Incorrectly doing overclock/overvoltage may result in damage to CPU, chipset, or memory
and reduce the useful life of these components. This page is for advanced users only and
we recommend you not to alter the default settings to prevent system instability or other
unexpected results. (Inadequately altering the settings may result in system's failure to
boot. If this occurs, clear the CMOS values and reset the board to default values.)
• When the System Voltage Optimized item blinks in red, it is recommended that you set
the System Voltage Control item to Auto to optimize the system voltage settings.
To Next Page
Loading...
