Gigabyte GA-MA790X-UD4P - Dram Configuration

- 4 1 - BIOS Setup
DRAM Configuration
CPU Host Clock Control, CPU Frequency (MHz), Set Memory Clock, Memory Clock
The settings under the four items above are synchronous to those under the same items in the
MB Intelligent Tweaker(M.I.T.).
DCTs Mode
(Note)
Allows you to set memory control mode.
Ganged Sets memory control mode to single dual-channel.
Unganged Sets memory control mode to two single-channel.(default)
DDRII Timing Items
Manual allows all DDRII Timing items below to be configurable.
Options are: Auto (default), Manual.
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
DRAM Configuration
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
CPU Host Clock Control [Auto]
x CPU Frequency (MHz) 200
Set Memory Clock [Auto]
x Memory Clock x2.66 533Mhz
DCTs Mode
(Note)
[Unganged]
DDRII Timing Items [Auto] SPD Auto
x CAS# latency Auto 5T 5T
x RAS to CAS R/W Delay Auto 4T 4T
x Row Precharge Time Auto 4T 4T
x Minimum RAS Active Time Auto 12T 12T
x 1T/2T Command Timing Auto - - - -
x TwTr Command Delay Auto 2T 2T
x Trfc0 for DIMM1 Auto 105ns 105ns
x Trfc2 for DIMM2 Auto - - - -
x Trfc1 for DIMM3 Auto - - - -
x Trfc3 for DIMM4 Auto - - - -
x Write Recovery Time Auto 4T 4T
x Precharge Time Auto 2T 2T
x Row Cycle Time Auto 17T 17T
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
DRAM Configuration
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
x RAS to RAS Delay Auto 2T 2T
(Note) This item is present only if you install a CPU that supports this feature.