Gigabyte GA-P35-DS3 - Page 26

GA-P35-DS3R/DS3/S3 Motherboard - 26 -
English
10) GSATAII0/1 (SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2, Purple)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The GIGABYTE SATA2 controller
supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions
on configuring a RAID array.
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
7
1
7
1
GSATAII0
GSATAII1
9) SATAII0/1/4/5 (SATA 3Gb/s Connectors, Controlled by ICH9, Orange)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device.
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
7
1
7
1
SATAII0
SATAII1
7
17
1
SATAII4
SATAII5
Only for GA-P35-DS3.
Only for GA-P35-S3.
Please connect the L-shaped end of the
SATA 3Gb/s cable to your SATA hard drive.