Gigabyte GA-P55A-UD4 - Onboard Parallel Port

- 55 - BIOS Setup
Onboard LAN1/LAN2
j
Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
Onboard USB 3.0 Controller (NEC D720200F1 USB Controller)
Enables or disables the NEC D720200F1 USB controller. (Default: Enabled)
Onboard IDE Controller (iTE IT8213 Chip)
Enables or disables the IDE controller integrated in the iTE IT8213 chip. (Default: Enabled)
eSATA Controller (JMicron JMB362 Chip, eSATA Connectors)
 EnablesordisablestheSATAcontrollerintegratedintheJMicronJMB362chip.(Default:Enabled)
eSATA Ctrl Mode (JMicron JMB362 Chip, eSATA Connectors)
 EnablesordisablesRAIDfortheSATAcontrollerintegratedintheJMicronJMB362chiporcongures
the SATA controller to AHCI mode.
IDE   DisablesRAIDfortheSATAcontrollerandcongurestheSATAcontrollertoIDE
mode. (Default)
AHCI   CongurestheSATAcontrollertoAHCImode.AdvancedHostControllerInterface
     (AHCI)isaninterfacespecicationthatallowsthestoragedrivertoenableadvanced
Serial ATA features such as Native Command Queuing and hot plug.
RAID Enables RAID for the SATA controller.
GSATA Controller (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Enables or disables the SATA controller integrated in the Marvell 9128 chip. (Default: Enabled)
GSATA Ctrl Mode (Marvell 9128 Chip, GSATA3_6/7 Connectors)
 AllowsyoutodecidewhethertoconguretheSATAcontrollerintegratedintheMarvell9128chipto
AHCI mode.
IDE   CongurestheSATAcontrollertoIDEmode.(Default)
AHCI   CongurestheSATAcontrollertoAHCImode.AdvancedHostControllerInterface
     (AHCI)isaninterfacespecicationthatallowsthestoragedrivertoenableadvanced
Serial ATA features such as Native Command Queuing and hot plug.
GSATA RAID Conguration (Marvell 9128 Chip, GSATA3_6/7 Connectors)
 AllowsyoutocongureRAIDfortheMarvell9128SATAcontroller.RefertoChapter5,"Conguring
SATAHardDrive(s),"forinstructionsonconguringaRAIDarray.
Onboard Serial Port 1
 EnablesordisablestherstserialportandspeciesitsbaseI/Oaddressandcorrespondinginterrupt.
Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.
Onboard Parallel Port
 Enablesordisablestheonboardparallelport(LPT)andspeciesitsbaseI/Oaddressandcorrespond-
ing interrupt. Options are: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
Selects an operating mode for the onboard parallel (LPT) port. Options are: SPP (Standard Parallel Port)
(default), EPP (Enhanced Parallel Port), ECP (Extended Capabilities Port), ECP+EPP.
j
Only for GA-P55A-UD4P.