Gigabyte GA-P55A-UD5 - Page 56

BIOS Setup - 56 -
Onboard LAN1/LAN2 Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
Onboard USB 3.0 Controller (NEC USB 3.0 Controller)
Enables or disables the USB 3.0 controller integrated in the NEC chip. (Default: Enabled)
Onboard IDE Controller (IT8213 Chip)
Enables or disables the IDE controller integrated in the IT8213 chip. (Default: Enabled)
eSATA Controller (JMicron JMB362 Chip, eSATA Connectors on the Back Panel)
Enables or disables the SATA controller integrated in the JMicron JMB362 chip. (Default: Enabled)
eSATA Ctrl Mode (JMicron JMB362 Chip, eSATA Connectors on the Back Panel)
Enables or disables RAID for the SATA controller integrated in the JMicron JMB362 chip or congures
the SATA controller to AHCI mode.
IDE Disables RAID for the SATA controller and congures the SATA controller to IDE
mode. (Default)
AHCI Congures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specication that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
RAID Enables RAID for the SATA controller.
GSATA Controller (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Enables or disables the SATA controller integrated in the Marvell 9128 chip. (Default: Enabled)
GSATA Ctrl Mode (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Allows you to decide whether to congure the SATA controller integrated in the Marvell 9128 chip to
AHCI mode.
IDE Congures the SATA controller to IDE mode. (Default)
AHCI Congures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specication that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
GSATA RAID Conguration (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Allows you to congure RAID for the Marvell 9128 SATA controller. Refer to Chapter 5, "Conguring
SATA Hard Drive(s)," for instructions on conguring a RAID array.
Onboard Serial Port 1
Enables or disables the rst serial port and species its base I/O address and corresponding interrupt.
Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.