Gigabyte GA-P55A-UD5 - Configuring Jmicron JMB362 SATA Controller

- 95 - Appendix
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Figure 1
Step 2:
Save changes and exit BIOS Setup.
5-1-2 Conguring JMicron JMB362 SATA Controller
A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. The JMicron JMB362 SATA controller controls the eSATA ports on the back
panel. Then connect the power connector from your power supply to the hard drive.
B. Conguring SATA controller mode in BIOS Setup
Make sure to congure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Make sure eSATA Controller under the Integrated Peripherals menu is enabled (Figure 1). To create RAID,
set eSATA Ctrl Mode to RAID.
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Integrated Peripherals
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

Turbo SATA3/USB3.0 [Auto]
Azalia Codec [Auto]
PCI Express x4/x1 Slot [Auto]
Onboard H/W 1394 [Enabled]
Onboard H/W LAN1 [Enabled]
Onboard H/W LAN2 [Enabled]
Green LAN [Disabled]

SMART LAN1 [Press Enter]

SMART LAN2 [Press Enter]
Onboard LAN1 Boot ROM [Disabled]
Onboard LAN2 Boot ROM [Disabled
Onboard USB 3.0 Controller [Enabled]
Onboard IDE Controller [Enabled]
eSATA Controller [Enabled]
eSATA Ctrl Mode [RAID]
GSATA Controller [Enabled]
GSATA Ctrl Mode [IDE]
 GSATARAIDConguration  [PressEnter]
Onboard Serial Port 1 [3F8/IRQ4]