- 33 -
LAN PXE Boot Option ROM &
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default:
Disabled)
SATA Controller(s) (Intel H61 Chipset) &
Enables or disables the integrated SATA controllers. (Default: Enabled)
SATA Mode Selection (Intel H61 Chipset) &
Allows you to decide whether to congure the SATA controllers integrated in the Intel H61 Chipset to AHCI
mode.
IDE Congures the SATA controllers to IDE mode. (Default)
AHCI Congures the SATA controllers to AHCI mode. Advanced Host Controller Interface (AHCI)
is an interface specication that allows the storage driver to enable advanced Serial ATA
features such as Native Command Queuing and hot plug.
USB Controller &
Enables or disables the USB 2.0 controllers integrated with the Intel H61 Chipset. (Default: Enabled)
Audio Controller &
Enables or disables the onboard audio function. (Default: Auto)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to
Disabled.
Init Display First &
Species the rst initiation of the monitor display from the installed PCI graphics card or the PCI Express
graphics card.
Auto Lets BIOS automatically congure this setting. (Default)
PEG Sets the PCI Express graphics card on the PCIEX16 slot as the rst display.
PCI Sets the PCI graphics card as the rst display.
Legacy USB Support &
Allows USB keyboard/mouse to be used in MS-DOS. (Default: Enabled)
USB3.0 Support (Etron EJ168 USB 3.0 Controllers) &
Enables or disables the Etron EJ168 USB 3.0 controllers. (Default: Enabled)
XHCI Hand-off &
Determines whether to enable XHCI Hand-off feature for an operating system without XHCI Hand-off
support. (Default: Enabled)
EHCI Hand-off &
Determines whether to enable EHCI Hand-off feature for an operating system without EHCI Hand-off
support. (Default: Disabled)
Port 60/64 Emulation &
Enables or disables emulation of I/O ports 64h and 60h. This should be enabled for full legacy support
for USB keyboards/mice in MS-DOS or in operating system that does not natively support USB devices.
(Default: Enabled)
USB Storage Devices &
Displays a list of connected USB mass storage devices. You can congure how each device is going to be
treated. For example, you can emulate a USB ash drive as a oppy disk drive. (Default: Auto)