Gigabyte GA-P67A-UD4-B3 - Page 49

- 49 - BIOS Setup
Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
R_USB30 Controller ( Back Panel Renesas D720200 USB Controller, USB Connectors
on the Back Panel)
Enables or disables the back panel Renesas D720200 USB controller. (Default: Enabled)
R_USB30 Turbo (Back Panel Renesas D720200 USB Controller, USB Connectors on
the Back Panel )
Enables or disables the Turbo USB mode for the back panel Renesas D720200 USB controller. The
actual performance may vary depending on the number of devices being installed. (Default: Disabled)
F_USB30 Controller ( Front Panel Renesas D720200 USB Controller, USB Connectors
on the Front Panel)
Enables or disables the front panel Renesas D720200 USB controller. (Default: Enabled)
eSATA3 Controller ( Marvell 88SE9128 Chip, eSATA Connectors on the Back Panel)
Enables or disables the SATA controller integrated in the Marvell 88SE9128 chip. (Default: Enabled)
eSATA3 Ctrl Mode ( Marvell 88SE9128 Chip, eSATA Connectors on the Back Panel)
 AllowsyoutodecidewhethertoconguretheSATAcontrollerintegratedintheMarvell88SE9128chip
to AHCI mode.
IDE   CongurestheSATAcontrollertoIDEmode.(Default)
AHCI   CongurestheSATAcontrollertoAHCImode.AdvancedHostControllerInterface
     (AHCI)isaninterfacespecicationthatallowsthestoragedrivertoenableadvanced
Serial ATA features such as Native Command Queuing and hot plug.
eSATA3 Transaction Mode ( Marvell 88SE9128 Chip, eSATA Connectors on the Back
Panel)
Allows you to decide whether to enable RAID for the Marvell 88SE9128 SATA controller.
Bypass Disables RAID.
Fw Mode Enables RAID. (Default)
Auto   LetstheBIOScongurethissettingdependingontheharddrivesconnected.
In case you want to switch to Fw Mode from other modes and to be able to enter the eSATA3 RAID
Conguration screen, after selecting Fw Mode,besuretosavethesettingsandexitBIOSSetuprst
for the settings to take effect.
eSATA3 RAID Conguration (Marvell 88SE9128 Chip, eSATA Connectors on the Back
Panel)
 AllowsyoutocongureRAIDfortheMarvell88SE9128SATAcontroller.RefertoChapter5,"Congur-
 ingSATAHardDrive(s),"forinstructionsonconguringaRAIDarray.
SATA3 Firmware Selection
DetermineswhethertoautomaticallyupdatethermwareoftheMarvell88SE9128chip.
Onchip  Keepstheoriginalrmwareversion.
Auto   LetstheBIOSautomaticallyupdatethermwaretothelatestversion.(Default)
Force   ForcestheBIOStoashthermwarewiththesameversionastheoneembeddedin
the system BIOS, even if it's not the latest one.
Onboard Serial Port 1
 EnablesordisablestherstserialportandspeciesitsbaseI/Oaddressandcorrespondinginterrupt.
Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.