Gigabyte GA-P67A-UD4-B3 - Page 93

- 93 - Appendix
Step 3:
On the next screen, press <Enter> to continue the driver installation. After the driver installation, you can pro-
ceed with the Windows XP installation.
For the Marvell 88SE9128:
InserttheoppydiskcontainingtheSATAAHCIdriverandpress<Enter>.Thescreenwilldisplaytwodriv-
ers, both of which need to be installed (Figure 2). First select Marvell shared library (install rst) and press
<Enter>. On the next screen, press <S> to return to the screen in Figure 2. Then select Marvell 91xx SATA
Controller 32bit Driverandpress<Enter>.Whenbothofthetwodriversappearontheconrmationscreen,
press <Enter> to continue the driver installation.
Figure 2
Windows Setup
  YouhavechosentocongureaSCSIAdapterforusewithWindows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
ENTER=Select F3=Exit
Marvellsharedlibrary(installrst)
Marvell 91xx SATA Controller 32bit Driver
B. Installing Windows 7/Vista
As Windows 7 and Vista already include SATA RAID/AHCI controller driver, you do not need to install sepa-
rate RAID/AHCI driver during the Windows installation process. After the operating system is installed, we
recommend that you install all required drivers from the motherboard driver disk using "Xpress Install" to
ensure system performance and compatibility.