- 41 - BIOS Setup
Init Display First
This feature allows you to select the first initiation of the monitor display from which card when you
install a PCI card and a PCI Express VGA card on the motherboard.
PCI Set Init Display First to PCI VGA card. (Default value)
Onboard Set Init Display First to onboard VGA.
PEG Set Init Display First to PCI Express VGA card.
Onboard VGA
This item allows the user to decide when to activate the onboard VGA function.
Enable If No Ext PEG
Activate the onboard VGA first only when no PCI Express VGA card is installed. (Default value)
Always Enable
Always activate the onboard VGA first, whether or not a PCI Express card is installed. If you wish
to set up a dual view configuration, set this item to Always Enable.
On-Chip Frame Buffer Size
Frame buffer size is the total amount of system memory allocated solely for the onboard graphics
controller. MS-DOS, for example, will use only this memory for display. Options are:
8MB+1~2MB for GTT (default), 1MB+1~2MB for GTT.
To Next Page
Loading...
