Gigabyte GA-X99-Ultra Gaming - Page 70

Conguring a RAID Set
- 70 -
Step 3:
On the Intel(R) Rapid Storage Technology menu, press <Enter> on Create RAID Volume to enter the Create
RAID Volume screen. Enter a volume name with 1~16 letters (letters cannot be special characters) under the
Name item and press <Enter>. Then, select a RAID level(Figure8).RAIDlevelssupportedincludeRAID0,
RAID1,Recovery,RAID10,andRAID5(theselectionsavailabledependonthenumberoftheharddrives
being installed). Next, use the down arrow key to move to Select Disks.
Step 4:
Under Select Disksitem,selecttheharddrivestobeincludedintheRAIDarray.Pressthe<Space>key
on the hard drives to be selected (selected hard drives are marked with "X"). Then set the stripe block size
(Figure 9). The stripe block size can be set from 4 KB to 128 KB. Once you have selected the stripe block
size, set the volume capacity.
Figure 8
Figure 9