Gigabyte GA-X99P-SLI - Page 11

- 11 -
Hardware Installation
Storage Interface  Chipset:
- 4 x SATA 6Gb/s connectors (sSATA3 0~3), supporting IDE and AHCI modes
only
(An operating system installed on the SATA3 0~5 ports cannot be used on the
sSATA 0~3 ports.)
USB  Chipset+Intel
®
Thunderbolt
™
3 Controller:
- 1 x USB Type-C
™
port on the back panel, with USB 3.1 support
- 1 x USB 3.1 Type-A port (red) on the back panel
 Chipset+Renesas
®
USB 3.0 Hub:
- 3 x USB 3.0/2.0 ports on the back panel
 Chipset:
- 4 x USB 3.0/2.0 ports (available through the internal USB headers)
- 8 x USB 2.0/1.1 ports (4 ports on the back panel, 4 ports available through
the internal USB headers)
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 1 x PCIe power connector
 1 x M.2 Socket 3 connector
 1 x SATA Express connector
 10 x SATA 6Gb/s connectors
 1 x CPU fan header
 1 x water cooling fan header (CPU_OPT)
 3 x system fan headers
 1 x front panel header
 1 x front panel audio header
 1 x S/PDIF Out header
 2 x USB 3.0/2.0 headers
 2 x USB 2.0/1.1 headers
 1 x Trusted Platform Module (TPM) header
 1 x Clear CMOS jumper
Back Panel
Connectors
 1 x PS/2 keyboard/mouse port
 1 x DisplayPort In port
 1 x USB Type-C
™
port, with USB 3.1 support
 1 x USB 3.1 Type-A port (red)
 3 x USB 3.0/2.0 ports
 4 x USB 2.0/1.1 ports
 1 x RJ-45 port
 1 x optical S/PDIF Out connector
 5 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Line In,
Line Out, Mic In)
I/O Controller  iTE
®
I/O Controller Chip
Hardware
Monitor
 System voltage detection
 CPU/System/Chipset temperature detection
 CPU/CPU OPT/System fan speed detection
 CPU/System/Chipset overheating warning
 CPU/CPU OPT/System fan fail warning
 CPU/CPU OPT/System fan speed control
* Whether the fan speed control function is supported will depend on the cooler you
install.