Gigabyte GA-Z170-HD3P - Page 7

Storage Interface  Chipset:
- 1 x M.2 Socket 3 connector
- 3 x SATA Express connectors
- 6 x SATA 6Gb/s connectors
- SupportforRAID0,RAID1,RAID5,andRAID10
* Refer to "1-7 Internal Connectors," for the supported congurations with the M.2,
SATA Express, and SATA connectors.
USB  Chipset+ASMedia
®
ASM1142 chip:
- 1 x USB Type-C
™
port on the back panel, with USB 3.1 support
- 1 x USB 3.1 port on the back panel
 Chipset:
- 7 x USB 3.0/2.0 ports (3 ports on the back panel, 4 ports available through
the internal USB headers)
- 6 x USB 2.0/1.1 ports (2 ports on the back panel, 4 ports available through
the internal USB headers)
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 1 x M.2 Socket 3 connector
 3 x SATA Express connectors
 6 x SATA 6Gb/s connectors
 1 x CPU fan header
 3 x system fan headers
 1 x front panel header
 1 x front panel audio header
 1 x S/PDIF Out header
 2 x USB 3.0/2.0 headers
 2 x USB 2.0/1.1 headers
 1 x Trusted Platform Module (TPM) header
 1 x Thunderbolt
™
add-in card connector
 1 x serial port header
 1 x parallel port header
 1 x Clear CMOS jumper
Back Panel
Connectors
 2 x USB 2.0/1.1 ports
 1 x PS/2 keyboard/mouse port
 1 x D-Sub port
 1 x DVI-D port
 1 x HDMI port
 3 x USB 3.0/2.0 ports
 1 x USB 3.1 port
 1 x USB Type-C
™
port, with USB 3.1 support
 1 x RJ-45 port
 6 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Side Speaker
Out, Line In, Line Out, Mic In)
I/O Controller  iTE
®
I/O Controller Chip
Hardware
Monitor
 System voltage detection
 CPU/System temperature detection
 CPU/System fan speed detection
- 7 -