- 12 -Hardware Installation
Internal
Connectors
1 x CPU Ratio Up button
1 x Settings Lock button
1 x Direct to BIOS button
1 x Memory Safe button
1 x OC PCIe switch
1 x OC Ignition button
1 x Clear Battery button
1 x DualBIOS switch
1 x BIOS switch
1 x onboard voltage measurement module
Back Panel
Connectors
2 x USB 2.0/1.1 ports
1 x PS/2 keyboard/mouse port
1 x DVI-D port
1 x OCPSW button
1 x Mini-DisplayPort
1 x HDMI port
5 x USB 3.0/2.0 ports
1 x USB Type-C
™
port, with USB 3.1 support
1 x USB 3.1 port
1 x RJ-45 port
1 x optical S/PDIF Out connector
5 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Line In,
Line Out, Mic In)
I/O Controller iTE I/O Controller Chip
Hardware
Monitor
System voltage detection
CPU/System/Chipset temperature detection
CPU/CPU OPT/System fan speed detection
CPU/System/Chipset overheating warning
CPU/CPU OPT/System fan fail warning
CPU/CPU OPT/System fan speed control
* Whether the fan speed control function is supported will depend on the cooler you
install.
BIOS 2 x 128 Mbit ash
Use of licensed AMI UEFI BIOS
Support for DualBIOS
™
Support for Q-Flash Plus
* The USB ash drive used must be a USB 2.0 ash drive.
PnP 1.0a, DMI 2.7, WfM 2.0, SM BIOS 2.7, ACPI 5.0
Unique Features Support for APP Center
* Available applications in APP Center may vary by motherboard model. Supported
functions of each application may also vary depending on motherboard specications.
- 3D OSD
- @BIOS
- Ambient LED
- AutoGreen
- Cloud Station
- EasyTune
- EasyRAID