Gigabyte GA-Z68X-UD3H-B3 - Sata 6 Gb;S Connectors; Clearing CMOS Jumper

- 27 - Hardware Installation
9) GSATA3_5/6 (SATA 6Gb/s Connectors, Controlled by Marvell 88SE9172 Chip)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Marvell 88SE9172 chip
supportsRAID0andRAID1.RefertoChapter5,"ConguringSATAHardDrive(s),"forinstructionson
conguringaRAIDarray.
ARAID0orRAID1congurationrequirestwoharddrives.
Please connect the L-shaped end of
the SATA cable to your SATA hard
drive.
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
7 1
7 1
DEBUG
PORT
G.QBOFM
GSATA3_5
GSATA3_6
10) CLR_CMOS (Clearing CMOS Jumper)
 Use thisjumpertoclear the CMOS values (e.g.dateinformationand BIOS congurations) andreset
the CMOS values to factory defaults. To clear the CMOS values, place a jumper cap on the two pins to
temporarily short the two pins or use a metal object like a screwdriver to touch the two pins for a few
seconds.
Always turn off your computer and unplug the power cord from the power outlet before clear- •
ing the CMOS values.
After clearing the CMOS values and before turning on your computer, be sure to remove the •
jumper cap from the jumper. Failure to do so may cause damage to the motherboard.
After system restart, go to BIOS Setup to load factory defaults (select Load Optimized De- •
faults)ormanuallycongurethe BIOS settings (refertoChapter2,"BIOSSetup,"forBIOS
congurations).
Open: Normal
Short: Clear CMOS Values