Gigabyte GA-Z68X-UD5-B3 - Configuring Marvell 88 Se9128 Sata Controllers

- 89 - Appendix
5-1-2 ConguringMarvell88SE9128SATAControllers
A.InstallingSATAharddrive(s)inyourcomputer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. The Marvell 88SE9128 SATA controller controls the eSATA ports on the back
panel. Then connect the power connector from your power supply to the hard drive.
B.ConguringSATAcontrollerandRAIDmodeinBIOSSetup
Make sure to congure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST. In BIOS Setup, go to
IntegratedPeripherals. To enable RAID, make sure eSATA3Controller is enabled. Then set eSATA3Ctrl
Mode to IDE or AHCI, depending on your requirements (Figure 1). (In AHCI mode, installation of the SATA
AHCI driver is required during Windows XP installation.) Refer to section, "5-1-3," for more details.
Figure 1
Step 2:
Then make sure eSATA3Transaction Mode is set to FwMode. To create a RAID array, press <Enter> on
the eSATA3RAIDCongurationitem to enter the RAID conguration menu. Skip this step if you do not want
to create RAID.
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Integrated Peripherals
eXtreme Hard Drive (XHD) [Disabled]
PCH SATA Control Mode [IDE]
SATA Port0-3 Native Mode [Enabled]
USB Controllers [Enabled]
USB Legacy Function [Enabled]
USB Storage Function [Enabled]
Azalia Codec [Auto]
Onboard H/W 1394 [Enabled]
Onboard H/W LAN [Enabled]
}
SMART LAN [Press Enter]
Onboard LAN Boot ROM [Disabled]
Onboard USB3.0 Controller [Enabled]
USB3.0 Turbo [Disabled]
eSATA3 Controller [Enabled]
eSATA3 Ctrl Mode [IDE]
eSATA3 Transaction Mode [Fw Mode]
 eSATA3RAIDConguration  [PressEnter]
SATA3 Firmware Selection [Auto]

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
}
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Step 3:
Save changes and exit BIOS Setup.