Gigabyte GA-Z68X-UD7-B3 - Page 48

BIOS Setup - 48 -
•None If no SATA devices are used, set this item to None so the system will skip
the detection of the device during the POST for faster system startup.
•Auto Lets the BIOS automatically detect SATA devices during the POST. (Default)
•Manual  Allowsyoutomanuallyenterthespecicationsoftheharddrivewhenthehard
drive access mode is set to CHS.
Access Mode Sets the hard drive access mode. Options are: Auto (default), CHS, LBA, Large.
IDE Channel 2, 3, 5, 7 Master, 4, 6 Master/Slave
Extended IDE Drive
 CongureyourSATAdevicesbyusingoneofthetwomethodsbelow:
•Auto Lets the BIOS automatically detect SATA devices during the POST. (Default)
•None If no SATA devices are used, set this item to None so the system will skip
the detection of the device during the POST for faster system startup.
Access Mode Sets the hard drive access mode. Options are: Auto (default), Large.
 Thefollowingeldsdisplayyourharddrivespecications.Ifyouwishtoentertheparametersmanually,
refer to the information on the hard drive.
Capacity Approximate capacity of the currently installed hard drive.
Cylinder Number of cylinders.
Head Number of heads.
Precomp Write precompensation cylinder.
Landing Zone Landing zone.
Sector Number of sectors.
Halt On
Allows you to determine whether the system will stop for an error during the POST.
All Errors Whenever the BIOS detects a non-fatal error the system boot will stop.
No Errors The system boot will not stop for any error.
All, But Keyboard The system boot will not stop for a keyboard error but stop for all other errors.
(Default)
Memory
 Theseeldsareread-onlyandaredeterminedbytheBIOSPOST.
Base Memory Also called conventional memory. Typically, 640 KB will be reserved for the
MS-DOS operating system.
Extended Memory The amount of extended memory.
Total Memory The total amount of memory installed on the system.