Gigabyte GA-Z68X-UD7-B3 - Integrated Peripherals

- 51 - BIOS Setup
2-6 Integrated Peripherals
eXtreme Hard Drive(XHD) (Intel Z68 Chipset)
Enables or disables the X.H.D function for the SATA controllers integrated in the Intel Z68 Chipset. When
set to Enabled, the PCH SATA Control Mode item below will be set to RAID(XHD) automatically. For
details on using the GIGABYTE X.H.D utility, refer to Chaper 4, "eXtreme Hard Drive (X.H.D)." (Default:
Disabled)
PCH SATA Control Mode (Intel Z68 Chipset)
 EnablesordisablesRAIDfortheSATAcontrollersintegratedintheIntelZ68Chipsetorconguresthe
SATA controllers to AHCI mode.
IDE   DisablesRAIDfortheSATAcontrollersandcongurestheSATAcontrollerstoIDE
mode. (Default)
RAID(XHD) Enables RAID for the SATA controllers.
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
Integrated Peripherals
eXtreme Hard Drive (XHD) [Disabled]
PCH SATA Control Mode [IDE]
SATA Port0-3 Native Mode [Enabled]
USB Controllers [Enabled]
USB Legacy Function [Enabled]
USB Storage Function [Enabled]
Azalia Codec [Auto]
Onboard H/W 1394 [Enabled]
Onboard H/W LAN1 [Enabled]
Onboard H/W LAN2 [Enabled]

SMART LAN1 [Press Enter]

SMART LAN2 [Press Enter]
Onboard LAN1 Boot ROM [Disabled]
Onboard LAN2 Boot ROM [Disabled
Onboard USB3.0 Controller [Enabled]
USB3.0 Turbo [Disabled]
Onboard USB3.0 Controller2 [Enabled]
GSATA3 Controller [Enabled]
GSATA3 Ctrl Mode [IDE]
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
Integrated Peripherals
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

GSATA3 Transaction Mode [Fw Mode]
 GSATA3RAIDConguration  [PressEnter]
eSATA3 Controller [Enabled]
eSATA3 Ctrl Mode [IDE]
eSATA3 Transaction Mode [Fw Mode]
 eSATA3RAIDConguration  [PressEnter]
SATA3 Firmware Selection [Auto]