- 27 - Hardware Installation
7) SATA2 2/3/4/5 (SATA 3Gb/s Connectors, Controlled by Intel Z77 Chipset)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device. The Intel Z77 Chipset supports RAID 0, RAID 1,
a RAID array.
7
7
1
1
Pin No.
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
6) SATA3 0/1 (SATA 6Gb/s Connectors, Controlled by Intel Z77 Chipset)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The "SATA3 0" and "SATA3 1"
connectors support RAID 0 and RAID 1. RAID 5 and RAID 10 can be implemented on the two connectors
with the "SATA2 2/3/4/5" and mSATA connectors.
(Note)
7 1
7 1
Pin No.
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
•
are to be used, the total number of hard drives must be an even number.
•
not have to be an even number.)
•
(Note) When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system performance
of the RAID set may vary depending on the devices being connected.
1
0
SATA3
SATA2
5 3
4 2
To Next Page
Loading...
