Gigabyte GA-Z97X-UD5H-BK - Page 28

- 28 -
Hardware Installation
9) GSATA3 6/7 (SATA 6Gb/s Connectors, Controlled by Marvell
®
88SE9172 Chips)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The Marvell
®
chip supports RAID 0 and RAID 1.
Refer to Chapter 3, "Conguring SATA Hard Drive(s)," for instructions on conguring a RAID array.
7
7
DEBUG
PORT
G.QBOFM
1
1
GSATA3
7
6
8) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors, Controlled by Intel
®
Z97 Chipset)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The Intel
®
Chipset supports RAID 0, RAID 1,
RAID 5, and RAID 10. Refer to Chapter 3, "Conguring SATA Hard Drive(s)," for instructions on conguring a
RAID array.
• To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SATA
Conguration," for more information.
• M.2, SATA Express, and SATA3 4/5 connectors can only be used one at a time. The SATA3 4/5
connectors will become unavailable when an M.2 SSD is installed.
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
1
0
7 1
7 1
DEBUG
PORT
G.QBOFM
SATA3
F_USB30
F_U
B_ 
F_  F_ 

_
B
BS_
B
SB_
B
_S

S_
_
B
_U
_
B


 
S  
 
123
 
123
 
123
 
123
1
1
1
1
BSS
S
_S 
SSU
 
1 2 3  
 S3
BSSS
U
 __ 3
F_USB3F
S  _
S  _
S  _
SF


B_
3 2
5 4
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
SATA3