Gigabyte GA-Z97X-UD5H-BK - Chapter 3 Configuring SATA Hard Drive(s); 3-1 Configuring Intel Z97 SATA Controllers

- 65 -
Conguring SATA Hard Drive(s)
Chapter3 ConguringSATAHardDrive(s)
3-1 ConguringIntel
®
Z97 SATA Controllers
A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available SATA
port on the motherboard. If there is more than one SATA controller on your motherboard, refer to "Chapter 1,"
"HardwareInstallation,"toidentifytheSATAcontrollerfortheSATAport.(Forexample,onthismotherboard,
the SATA3 0/1/2/3/4/5 ports are supported by the Intel
®
Z97Chipset.)Thenconnectthepowerconnectorfrom
your power supply to the hard drive.
(Note1) SkipthisstepifyoudonotwanttocreateRAIDarrayontheSATAcontroller.
(Note2) RequiredwhentheSATAcontrollerissettoAHCIorRAIDmode.
TocongureSATAharddrive(s),followthestepsbelow:
A. InstallSATAharddrive(s)inyourcomputer.
B. CongureSATAcontrollermodeinBIOSSetup.
C. CongureaRAIDarrayinRAIDBIOS.
(Note1)
D. Install the SATA RAID/AHCI driver and operating system.
(Note2)
Before you begin, please prepare the following items:
Please prepare:
• AtleasttwoSATAharddrives(toensureoptimalperformance,itisrecommendedthatyouusetwoharddrives
withidenticalmodelandcapacity).IfyoudonotwanttocreateRAID,youmayprepareonlyoneharddrive.
• Windows setup disk.
• Motherboard driver disk.
• A USB thumb drive.
RAID Levels
RAID 0 RAID 1 RAID 5 RAID 10
Minimum
Number of Hard
Drives
≥2 2 ≥3 ≥4
Array Capacity Number of hard
drives*Sizeofthe
smallest drive
Sizeofthesmallest
drive
(Numberofhard
drives-1)*Sizeof
the smallest drive
(Numberofhard
drives/2)*Sizeofthe
smallest drive
Fault Tolerance No Yes Yes Yes