GN-B49G High-Speed Wireless Broadband Router
68
Response :
• Check that the power cord is connected properly, and the
router’s power LED is lit green.
• Verify that all the TCP/IP configuration settings are correct.
(Problem 1 above)
• Check that your ADSL/Cable Modem is operating normally,
and/or you have ISP service available.
• Check that all network cabling is properly connected.
Problem 3: When I Configure WDS bridging, my Wi-Fi Protected
Access (WPA) security is cancelled.
Response: Wi-Fi Protected Access (WPA) and Wireless Distribution
System (WDS) cannot be used at the same time.
If you need to secure a WDS network, use the Wireless
Encryption Protocol (WEP) feature instead.
If you must use WPA, connect your base stations to a wired
local area network (LAN).
To Next Page
Loading...