Gigabyte MC62-G40 - Page 76

- 76 -
BIOS Setup
Parameter
Description
NBIO RAS Common
Options (continued)

NBIO SyncFlood Reporting
– The value may be used to enable SyncFlood reporting to APML.
– Options available: Auto, Enabled, Disabled. Default setting is Auto.

Egress Poison Mask High
– Enables mask for masking of errors logged in EGRESS_POISON_
STATUS. For each bit set to 1, errors are masked. For each bit set to 0,
errors trigger response actions.

Egress Poison Mask Low
– Enables mask for masking of errors logged in EGRESS_POISON_
STATUS. For each bit set to 1, errors are masked. For each bit set to 0,
errors trigger response actions.

Uncorrected Converted to Poison Enable Mask High
– Enables mask for masking of uncorrectable parity errors on internal
arrays.

Uncorrected Converted to Poison Enable Mask Low
– Enables mask for masking of uncorrectable parity errors on internal
arrays.

System Hub Watchdog Timer
– SpeciesthetimerintervaloftheSYSHUBWatchdogtimerin
milliseconds.

SLINK Read Response OK
– ThisitemspecieswhetherSLINKreadresponseerrorsareconverted
to an Okay response.
– Options available: Enabled, Disabled. Default setting is Disabled.

SLINK Read Response Error Handling
– Options available: Enabled, Trigger MCOMMIT Error, Log Errors in
MCA. Default setting is Log Errors in MCA.

Log Poison Data from SLINK
– Enable/Disable the Log Poison Data from SLINK feature.
– Options available: Enabled, Disabled. Default setting is Disabled.

PCIe Aer Reporting Mechanism
– Selects the method of reporting AER errors from PCI Express.
– Options available: Auto, Firmware First, OS First, MCA. Default setting
is Auto.

Edpc Control
– Options available: Auto, Enabled, Disabled. Default setting is Auto.

NBIO Poison Consumption
– Options available: Auto, Enabled, Disabled. Default setting is Auto.

Sync Flood on PCIe Fatal Error
– Options available: Auto, True, False. Default setting is Auto.
Enable AER Cap
Enable/Disable Advanced Error Reporting Capability.
Options available: Auto, Enable, Disabled. Default setting is Auto.