Gigabyte R182-M80 - Page 13

Hardware Installation - 13 -
Internal I/O  2 x SATA 7-pin connectors
 2 x CPU fan headers
 1 x USB 3.0 header
 1 x TPM header
 1 x VROC connector
 1 x Front panel header
 1 x HDD back plane board header
 1 x IPMB connector
 1 x Clear CMOS jumper
 1 x BIOS recovery switch
Front I/O  1 x USB 3.0
 1 x Power button with LED
 1 x ID button with LED
 1 x Reset button
 1 x NMI button
 2 x LAN activity LEDs
 1 x HDD activity LED
 1 x System status LED
Rear I/O
 2 x USB 3.0
 1 x VGA
 2 x RJ45
 1 x MLAN
 1 x ID button with LED
Backplane I/O  4 x 3.5" or 2.5" SATA/SAS ports
 4 x 2.5" SATA/NVMe hybrid ports
 Bandwidth: PCIe Gen4 x4 or SATA 6Gb/s or SAS 12Gb/s per port
TPM  1 x TPM header with SPI interface
 Optional TPM2.0 kit: CTM010
Power Supply  1+1 80 PLUS Platinum 1300W redundant PSU
 AC Input:
100-240V~/ 12-7A, 50-60Hz
200-240V~/ 8A, 50-60Hz
 DC Input:
240Vdc/ 6.5A
 DC Output:
- Max 1000W/ 100-240V~
+12V/ 80.5A
+12Vsb/ 3A
- Max 1300W/ 200-240V~ or 240Vdc Input
+12V/ 105.4A
+12Vsb/ 3A