Gigabyte R282-3C0 - Page 13

- 13 - Hardware Installation
Storage R282-3C0
 8 x 3.5" or 2.5" SATA/SAS hot-swappable HDD/SSD bays
 4 x 3.5" or 2.5" SATA/SAS/Gen4 NVMe hot-swappable HDD/SSD bays
 2 x 2.5" SATA/SAS hot-swappable HDD/SSD bays in rear side
R282-3C1
 8 x 3.5" or 2.5" SATA/SAS hot-swappable HDD/SSD bays
 4 x 3.5" or 2.5" SATA/SAS/Gen4 NVMe hot-swappable HDD/SSD bays
 2 x 2.5" SATA/SAS hot-swappable HDD/SSD bays in rear side ( Connected via
SAS Expander)
 Broadcom SAS35x36R expander
 Bandwidth: SATA 6Gb/s or SAS 12Gb/s per port
 Default conguration supports:
 4 x 2.5" NVMe drives, non-supported SATA/SAS drives without SAS card
 Suggested 12Gb/s SAS cards: CRA4448
SAS R282-3C0
 N/A
R282-3C1
 Supported by optional SAS Card
RAID R282-3C0
 Intel® SATA RAID 0, 1, 10, 5
R282-3C1
 Depends on SAS Card
Internal
Connectors
 2 x CPU fan headers
 1 x USB 3.0 header
 1 x TPM header
 1 x VROC connector
 1 x Front panel header
 1 x HDD back plane board header
 1 x IPMB connector
 1 x Clear CMOS jumper
 1 x BIOS recovery switch
Front Panel
LED/Buttons
 2 x USB 3.0
 1 x Power button with LED
 1 x ID button with LED
 1 x Reset button
 1 x NMI button
 1 x System status LED
 1 x HDD activity LED
 2 x LAN activity LEDs
Rear Panel I/O  2 x USB 3.0
 1 x VGA
 2 x RJ45
 1 x MLAN
 1 x ID button with LED