Gigabyte R282-Z94 - Page 91

- 91 - BIOS Setup
Parameter Description
RedirectForReturnDis
From a workaroud for GCC/C000005 issue for XV Core on CZ A0,
setting MSRC001_1029 Decode Conguration (DE_CFG) bit 14
[DecfgNoRdrctForReturns] to 1.
Options available: Auto/1/0. Default option is Auto.
Platform First Error Warning
Enable/Disable PFEH, cloak individual banks, and mask deferred error
interrupts from each bank.
Options available: Enabled/Disabled/Auto. Default option is Enabled.
Core Performance Boost
Allows you to disable CPB.
Options available: Disabled/Auto. Default option is Auto.
Global C-State Control
Controls the IO based C-state generation and DF C-states.
Options available: Disabled/Enabled/Auto. Default option is Auto.
Power Supply Idle Control
Congures the power supply idle control.
Options available: Low Current Idle/Typical current Idle/Auto. Default
option is Auto.
Opcache Control
Enables or disables the Opcache.
Options available: Disabled/Enabled/Auto. Default option is Auto.
SEV ASID Count
This eld species the max. valid ASID, which affects the maximum
system physical address space. 16TB of physical address space is
available for systems that support 253 ASIDs, while 8TB of physical
address space is available for systems that support 509 ASIDs.
Options available: 253 ASIDs/509 ASIDs/Auto. Default option is Auto.
SEV-ES ASID Space Limit
Control
Space limit control for SEV-ES ASIDs.
Options available: Auto/Manual. Default option is Auto.
Streaming Stores Control
Enables or disables the streaming stores functionality.
Options available: Disabled/Enabled/Auto. Default option is Auto.
Local APIC Mode
Sets the Local APIC mode.
Options available: xAPIC/x2APIC/Auto. Default option is Auto.
ACPI_CST C1 Decaration
Determines whether or not to declare the C1 state to the OS.
Options available: Disabled/Enabled/Auto. Default option is Auto.
MCA error thresh enable
Enable MCA error thresholding.
Options available: False/True/Auto. Default option is Auto.
SMU and PSP Debug Mode
When this option is enabled, specic uncorrected errors detected by the
PSP FW or SMU FW will hand and not reset the system.
Options available: Disabled/Enabled/Auto. Default option is Auto.