Gigabyte TRX40 AORUS XTREME - RAID and Driver Installation; Configuring RAID Sets

- 61 -
Conguring a RAID Set
TocongureSATAharddrive(s),followthestepsbelow:
A. Install hard drive(s) in your computer.
B. CongureSATAcontrollermodeinBIOSSetup.
C. CongureaRAIDarrayinRAIDBIOS
(Note 1)
D. Install the SATA RAID/AHCI driver and operating system
Before you begin
• At least two SATA hard drives or SSDs
(Note 2)
(to ensure optimal performance, it is recommended that you
use two hard drives with identical model and capacity).
(Note 3)
• A Windows setup disc.
• AORUSUSBashdrivewithdrivers.
3-1 ConguringSATAControllers
A. Installing SATA hard drive(s) in your computer
Install the hard drives/SSDs in the SATA/M.2 connectors on the motherboard. Then connect the power
connectors from your power supply to the hard drives.
RAID Levels
RAID 0 RAID 1 RAID 10
Minimum Number of
Hard Drives
≥2 2 4
Array Capacity Number of hard drives *
Size of the smallest drive
Size of the smallest drive (Number of hard drives/2) *
Size of the smallest drive
Fault Tolerance No Yes Yes
(Note 1) Skip this step if you do not want to create RAID array on the SATA controller.
(Note 2) An M.2 PCIe SSD cannot be used to set up a RAID set either with an M.2 SATA SSD or a SATA hard drive.
(Note 3) Refer to "Internal Connectors," for the installation notices for the M.2, and SATA connectors.
Chapter3 ConguringaRAIDSet