Gigabyte W480 VISION D - Page 50

BIOS Setup
- 50 -
 IO Ports
& Initial Display Output
 SpeciestherstinitiationofthemonitordisplayfromtheinstalledPCIExpressgraphicscardortheonboard
graphics.
IGFX
(Note)
  Setstheonboardgraphicsastherstdisplay.
PCIe1Slot SetsthegraphicscardonthePCIEX16slotastherstdisplay.(Default)
PCIe2Slot SetsthegraphicscardonthePCIEX8slotastherstdisplay.
PCIe3Slot SetsthegraphicscardonthePCIEX4slotastherstdisplay.
& Internal Graphics
Enables or disables the onboard graphics function. (Default: Auto)
& DVMT Pre-Allocated
 Allowsyoutosettheonboardgraphicsmemorysize.Optionsare:32M~512M.(Default:64M)
& DVMT Total Gfx Mem
 AllowsyoutoallocatetheDVMTmemorysizeoftheonboardgraphics.Optionsare:128M,256M,MAX.
(Default: 256M)
& Aperture Size
Allows you to set the maximum amount of system memory that can be allocated to the graphics card.
Options are: 128MB, 256MB, 512MB, 1024MB, and 2048MB. (Default: 256MB)
& PCIE Bifurcation Support
 AllowsyoutodeterminehowthebandwidthofthePCIEX16slotisdivided.Options:Auto,PCIEx8/x8,
PCIEx8/x4/x4.(Default:Auto)
& USB 3.0 DAC-UP 2 (Output Voltage of USB DAC-UP 2 Ports on the Back Panel)
Allows you to increase the output voltage of the USB DAC-UP 2 ports on the back panel (the ones below
the LAN1 port) to strengthen the stability of your USB device(s).
Normal Keeps the original output voltage. (Default)
Disable USB bus power Disables the power of the USB connectors. High-end audio players may
connect their own external USB power source.
Voltage Compensation +0.1V Adds 0.1V to the original output voltage.
Voltage Compensation +0.2V Adds 0.2V to the original output voltage.
Voltage Compensation +0.3V Adds 0.3V to the original output voltage.
(Note) This item is present only when you install a CPU that supports this feature.